What's included in our faucet and sink repair in Oklahoma City
We work on kitchen, bathroom, bar, laundry and utility sinks, and on the faucets that serve them:
- Faucet repairs. Cartridges, stems, washers, O-rings, handles and diverters for sprayers.
- Flow problems. Cleaning or replacing clogged aerators and checking supply valves that are only partly open.
- Supply side. New braided supply lines and quarter-turn shutoff valves.
- Drain side. P-traps, slip nuts, tailpieces, pop-up stoppers and leaking drain baskets.
- Faucet replacement when repair no longer makes sense.
Faucet types and how they fail
Knowing the design tells us which part is worn before we take anything apart.
| Faucet type | How to spot it | What usually wears out |
| Compression | Two handles you tighten down to close | Rubber washers and valve seats |
| Cartridge | One or two handles that move smoothly | The cartridge and its O-rings |
| Ball | A single handle over a rounded cap | Springs, seats and the cam seal |
| Ceramic disc | A single lever over a wide cylinder | Inlet seals, or a disc cracked by debris |
Many name-brand faucets use a cartridge made for that one product line, so we identify the brand and model before we order or swap parts. A faucet that drips only on the hot side, or only on the cold, tells us which half of the valve has worn.
Kitchen faucets, bathroom faucets and tub spouts
Each kind of faucet has its own weak spots. On kitchen faucets, pull-down and pull-out sprayers use a flexible hose under the sink that can wear through, kink or leak at its quick-connect fitting, and older side sprayers depend on a diverter that sticks with mineral buildup. Bathroom faucets tend to leak around the handle or at the pop-up stopper rod under the basin. Tub and shower faucets hide their cartridge behind the wall, so a drip from the tub spout or showerhead means pulling the trim and replacing the cartridge or stem from the front. In most cases we can do that from the front without opening the tile.
When the sink itself needs repair
Sometimes the faucet is fine and the sink is the problem. Undermount sinks can sag or pull away from the countertop when the clips or adhesive fail, which lets water run down into the cabinet. Old caulk lines crack and let water get under the rim. Bathroom sinks with an overflow hole can leak where the overflow channel meets the drain. A drain flange that has worked loose drips every time the basin is full. We reset, reseal or resecure the sink, and if a basin is cracked, we replace it and reconnect the plumbing.
Leaks under the sink
A wet cabinet can come from four or five places, and a quick wipe and look usually finds it. Supply lines crack with age, especially old plastic ones, and a burst line under a sink can flood a kitchen fast. Shutoff valves leak at the stem or freeze in place; the plumbing code Oklahoma uses requires a shutoff on the supply to each fixture other than tubs and showers, and we make sure yours works. P-traps leak at loose slip nuts or rust through if they are old metal. Drain baskets leak when the putty or gasket under the rim dries out.
Kitchen sinks add more connections. A dishwasher drain hose and a garbage disposal both tie into the drain, and either one can leak where it joins.
Repair or replace the faucet?
Repairing a quality faucet is usually the better value. Replacing it is the better choice when the body is corroded, the finish is flaking or parts are discontinued. The plumbing code limits sink faucets to 2.2 gallons per minute at 60 psi. EPA WaterSense bathroom faucets go further, at a maximum of 1.5 gallons per minute, which EPA says can cut a sink's flow by 30 percent or more and save the average family 700 gallons a year. If you are updating several fixtures, our fixture installation service handles the whole bathroom or kitchen.
What affects the cost of faucet and sink repair
- The part. A washer costs less than a brand-specific cartridge.
- Access. Corroded nuts behind a deep basin or a tight vanity take longer.
- Extras. New shutoff valves, a trap or a replacement faucet add to the job.
You get the price for your actual repair before we start, and financing is available for larger jobs.
Faucet and sink problems in Oklahoma City homes
In older Oklahoma City homes, galvanized supply pipe can shed rust and scale into aerators and cartridges, so a faucet that keeps clogging may be telling you about the pipes behind the wall. Any time water service is shut off and restored, whether for a city main repair or work in your own house, loosened sediment can land in the same places. If every faucet in the house runs weak, it is time to look at water pressure repair instead of the fixtures. And if the sink drains slowly no matter what, the clog is further down the line, where drain cleaning takes over. To see who you are hiring, read about our team.